This RepRap Mendel hardware kit includes all the bolts, nuts, washers, threaded and smooth rod needed to build your Prusa Mendel. Most bolts, nuts, and washers come with a few extras in case one gets lost. The rods are nice and straight. It is all packed tight and ships well. All studding and bar length cut to +0.8mm , - 0.0mm ends ground and ready for use.

Includes:

6 - M2.5 Cap Screw 20mm
6 - M2.5 Nut
12 - M2.5 Washer
24 - M3 Cap Screw 10mm
16 - M3 Cap Screw 25mm
4 - M3 Cap Screw 40mm
40 - M3 Nut
70 - M3 Washer
2 - M4 Cap Screw 20mm
2 - M4 Nut
2 - M4 Washer
1 - M8 Hex Bolt 30mm
83 - M8 Nut
93 - M8 Washer
6 - M8 x 30 Fender Washer
3 - Bearing, 8mm x 22mm x 7mm
2 - M8 x 210mm zinc steel threaded rod
4 - M8 x 294mm zinc steel threaded rod
6 - M8 x 370mm zinc steel threaded rod
3 - M8 x 440mm zinc steel threaded rod
2 - 8mm x 350mm Stainless Steel Alloy 303, Precision Ground Bar
2 - 8mm x 406mm Stainless Steel Alloy 303, Precision Ground Bar
2 - 8mm x 420mm Stainless Steel Alloy 303, Precision Ground Bar

* Using 3/16" x 3/4" fender washer to replace M5x20 mudguard washer
All threaded rod, nuts, and bolts are metric as required of the Mendel documents.

Does not include extruder hardware, springs or belts